background image

 2

Table of Contents

Safety Information .....................................................2

Warranty.....................................................................2

Pre-Installation ..........................................................3 

Junction Box Installation ..........................................5

Conduit Installation ...................................................6

Maintenance ..............................................................7

Battery Replacement .................................................8

Troubleshooting .........................................................8

Safety Information

IMPORTANT SAFEGUARDS. READ AND FOLLOW 

ALL SAFETY INSTRUCTIONS.

When using electrical equipment, basic safety precautions should 
always be followed including the following:

 

Consult your local building code for approved wiring and 
installation guidelines.

 

This product is for indoor use only.

 

Do not mount this product near a gas or electric heater.

 

This product should be mounted in a location and at a 
height where it will not be readily subjected to tampering by 
unauthorized personnel.

 

The use of accessories is not recommended by the 
manufacturer, and my cause unsafe conditions.

 

Do not use this product for anything other than its intended use.

 

All service shall be performed by qualified service personnel. 
This product must be installed and maintained in accordance 
with the applicable installation codes by a person familiar with 
the construction operation of the product and the hazards 
involved. 

 

Maximum mounting height is 27.14 ft. (8.27 m) or the equivalent. 

WARNING:

 Before beginning installation, turn off electricity 

by removing the fuse or turning off the circuit breaker.

SAVE THESE INSTRUCTIONS

WARNING:

 Disconnect power before servicing the 

product. All service should be performed by a qualified 
electrician.

WARNING:

 Changes or modifications to this unit 

not expressly approved by the party responsible for 
compliance could void the user’s authority to operate the 
equipment.

NOTICE:

 This equipment has been tested and found to comply with 

the limits for a Class B digital device, pursuant to Part 15 of the FCC 
Rules. These limits are designed to provide reasonable protection 
against harmful interference in a residential installation. This 
equipment generates, uses and can radiate radio frequency energy 
and, if not installed and used in accordance with the instructions, 
may cause harmful interference to radio communications. However, 
there is no guarantee that interference will not occur in a particular 
installation. If this equipment does cause harmful interference to 
radio or television reception, which can be determined by turning the 
equipment off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures:

 

Reorient or relocate the receiving antenna.

 

Increase the separation between the equipment and receiver.

 

Connect the equipment into an outlet on a circuit different from 
that to which the receiver is connected.

 

Consult the dealer or an experienced radio/TV technician for help.

Warranty

WHAT IS COVERED

The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for a period of five (5) years, 

and five (5) years for the battery, from date of purchase. This warranty applies only to the original consumer purchaser and only 

to products used in normal use and service. If this product is found to be defective, the manufacturer’s only obligation, and your 

exclusive remedy, is the repair or replacement of the product at the manufacturer’s discretion, provided that the product has not 

been damaged through misuse, abuse, accident, modifications, alterations, neglect, or mishandling.

WHAT IS NOT COVERED

This warranty shall not apply to any product that is found to have been improperly installed, set-up, or used in any way not in 

accordance with the instructions supplied with the product. This warranty shall not apply to a failure of the product as a result of an 

accident, misuse, abuse negligence, alteration, faulty installation, or any other failure not relating to faulty material or workmanship. 

This warranty shall not apply to the finish on any portion of the product, such as surface and/or weathering, as this is considered 

normal wear and tear.
The manufacturer does not warrant and specifically disclaims any warranty, weather express or implied, of fitness for a particular 

purpose, other than the warranty contained herein. The manufacturer specifically disclaims and liability and shall not be liable for 

any consequential or incidental loss or damage, including but not limited to any labor / expense costs involved in the replacement or 

repair of said product.
Contact the Customer Service Team at 1-877-527-0313 or visit www.HomeDepot.com.

Summary of Contents for 1003 821 752










Reviews: