USER GUIDE
7
Light fixtures can be quickly removed from the tripod by twisting the knurled portion of light
head coupler counterclockwise, allowing storage of the light head in a different location than the
tripod and the use of multiple different light heads or light bars with a single tripod. Be careful
when removing or re-attaching the light heads. Not aligning the electrical connectors correctly can
cause damage to the connectors.
Operation
•
Loosen the main knob and extend the legs as far as possible for the best stability and height,
tighten the knob to lock the legs in place.
•
The rear leg can be extended for use on uneven surfaces. Loosen the extension leg knob and
extend the foot out to the desired length, keeping the mast of the tripod as vertical as
possible, then tighten the knob.
•
For added stability in high wind conditions or extreme terrain place sandbags at the base of
the legs.
•
Insert (1) battery into the battery receiver until it clicks.
•
Battery removal will get easier with more remove/replace cycles.
•
Adjust the light angle by using the swivel directly below the light fixture.
•
Loosen the lock collar at the top of the primary mast by turning it counterclockwise. Extend
the inner mast to the desired height and tighten the lock collar by turning it clockwise.
Reduce glare by extending the inner mast completely.
•
Use caution not to direct the light in a way that will inhibit other’s visibility.
•
Press the power button on the battery receiver once to turn on the light. The light fixture will
blink three times to warn of low-battery conditions.
•
If using truck power, insert the truck power connector into the battery receiver and the truck
power outlet located on the vehicle. The light will turn on as soon as everything is connected,
the power button is not used during truck power operation. There may be an in-cab power
button or switch that will turn power on and off to the power outlet.
•
If using shore power, insert the shore power connector into the battery receiver and use an
extension cord to connect to 115V AC power source. The light will turn on as soon as
everything is connected, the power button is not used during shore power operation.
•
Before transporting, be sure the lock collar and all knobs are tightened after lowering the
inner mast and folding in the legs.