Command Light CL602A, Manual, Page: 19 / 48

USER GUIDE
18
Power Failure
The COMMAND LIGHT can be retracted manually if power to the unit is lost. If power loss is
temporary, reestablishing power may be easier than manually retracting the light.
Note: Disconnect power source from the COMMAND LIGHT before manual operation.
WATCH THE VIDEO AT WWW.COMMANDLIGHT.COM/TECHNICAL-VIDEOS/
Rotate to center
Slowly apply pressure to the rotation platform to manually rotate to the centered position. Trying to
rotate the platform too quickly or with too much pressure can break the rotation motor shaft. Be certain
that you rotate the platform in the proper direction. The upper stage can rotate a full 360˚. Generally
you need to rotate the platform in the direction that requires the least amount of travel in order to center
the platform.
Retract the Lower Stage
Locate the silver plug located on lower actuator below the lower actuator’s motor. Use the provided hex
tool to remove silver plug. Be sure to not lose this plug. Use the same hex tool inserted into the opening
to drive the internal gears of the actuator. Be sure to replace the silver plug after this actuator is fully
retracted. Be careful not to hit the lower lamps on main electrical box if your tower has the Backlight
option and the lamps are not flush with the fixed lamps.
Retract The Upper Stage
To access the upper actuator mechanism it is necessary to remove the main cover. Remove
the 16 screws using a #2 Phillips head screwdriver. There are 12 screws on top and 2 on
either end of the main cover. Use the same hex bit and method as above in “Retract The
Lower Stage First” to retract the upper actuator.