STEP 3
- Install MM3 & Reassemble Device
A. Slide push pad with motor kit back into the device. Also, the filler plate must be slid in at same time.
B. Make sure Latch retractor is pressed down so push pad slides over it.
C. Re-install original screws in holes 1 & 2. Install new screws provided in holes 3 & 4.
Step 1
-
Select your preferred torque mode (ships in standard torque) Press the
device push pad to the desired setting. (Recommend to fully depress and
release 5%, giving the device room for changing door conditions.)
Step 2
-
While depressing the push pad, apply power. (i.e. Presenting the
credential to the reader).
Step 3
-
Continue to keep pad depressed, the device will beep 6 times. After
the beeps have stopped, release the pad and now the adjustment is
complete. If not to your liking repeat the 3 steps.
S
etting
ptS
Step 4
-
Once you found the correct location, flip the dip switches to off to lock programming.
ON
OFF
OFF
OFF
ON
OFF
Low Torque
Standard Torque
PTS programming locked
ON ON High Torque
1
S
witch
p
rogram
2
