7
Slide push pad off of baserail.
Drill the hole for our 2 pin power lead in-
between the 2 mounting screws.
B.
C.
Feed the 2 pin power lead into the hole
and connect to our MM4 module. Also,
make sure to clean out any debris left.
D.
Debris
Note: Depending on where your power transfer is; next you would fish the other side of the power
lead we connected to the MM4 and hook up to your incoming power. If you have a portable tester
this would be a good time to test fire the motor.
Summary of Contents for PD10-M-RIM
Page 11: ...11 PD10 Parts Breakdown ...