12
Removing a Sensor from the Network
In case a device must be removed from your OmniShield network,
the network data must be removed from the unit’s memory.
Adding a Sensor to the Network
To add a device to an existing OmniShield Network, perform the
following steps.
Step 1 - Press and hold the button on the
Comm Link. The FIRE icon will flash red and
the horn will sound three times. Continue
holding.
Step 2 - The WARNING icon will begin to
flash yellow. Count the yellow flashes.
Step 3 - Release the button on the 5th flash.
The blue RADIO icon will begin to flash. This
signals that the Comm Link is ready to add
new sensors.
Step 4 - Add the new sensors in the same
manner as described on page 11.
Step 5 - The new device will appear on the
Sensors tab of the OmniShield App.
Repeat Steps 1 & 2 listed above on the
device to be removed from the network.
Step 3 - Release the button on the 10th flash.
The alarm will chirp twice and all four icons
will strobe briefly on.
All network data has been erased from
the sensor.
Delete this sensor from the
App.
Following Steps 1-3 above on the Comm Link, release the button on
15 flashes.
The Comm Link will delete any WiFi network connec-
tion/passwords that it has stored. A new WiFi network or Ethernet
connection must be added for the Comm Link to function.
Deleting the WiFi Network