- 9 -
Version: May 2011
FILLING THE SPA
Please note: If your spa is
equipped with water booster seats
attach them now and fill with
water and burp air out before
proceeding.
1. Ensure that the power pack is
not plugged in.
2.
Remove the protective caps from
the suction and discharge fittings
inside the spa. Place the caps in a
safe location.
3.
Using a garden hose, fill the spa
with approximately 1/2 inch of water.
STOP!
With hands, smooth out
any wrinkles on bottom of liner,
starting from the center of liner and
proceeding outwards towards the
wall.
Be careful not to over fill the spa, or
the spa may overflow during use.
Each average adult will raise the
water level in the spa approximately
two inches, and the turbo wave
blower action will raise water level an
additional three to four inches.
4. Bleed the air from the filter tank by
turning the small black knob on the
top of the filter tank
counterclockwise. Allow the filter
tank to bleed for approximately one
minute, or until water drips from the
fitting. Turn the fitting clock-wise to
close the bleed valve.
Plug the spa into a properly
grounded electrical outlet.
Meijer.com
