3
3
www.comfortzoneproducts.com
USAGE
HEATER OPERATION:
Always operate the heater in the upright
position following all instructions and recommendations listed in
this manual.
HEATER LOCATION:
Place the heater in the area of the room
that is coldest. The heater should not be placed immediately
under a power outlet.
HEATER CONNECTION:
Plug heater directly into 120 Volt A.C.,
60Hz wall outlet. Be sure plug fits tightly in outlet. A loose
connection may cause overheating and damage to the plug or
heater.
NOTE:
To prevent overloading a circuit, do not plug the heater
into a circuit that is servicing other electrical needs.
TURNING HEATER ON
For Flame Effect Only,
Slide the Main Power ON/OFF Switch to ON
«—»
position to
have the 3-D flame effect without heat.
For Low Heat – 750 watts,
Slide the Main Power ON/ OFF Switch to ON
«—»
position
and slide switch to ON
«—»
position.
For High Heat – 1500 watts,
Slide the Main Power ON/ OFF Switch to ON
«—»
position and
slide both switch and switch to ON
«—»
positions.
CONTROL PANEL
on the side panel of heater
ON/OFF Switch:
Main Power and Simulated flame
(without heat )
Adjustable Thermostat
Two Switches for HEAT SETTINGS:
•Switch = Low (750W)
•Switch + Combined = High (1500W)
TURNING HEATER OFF
Slide the Main Power Switch OFF
«O»
to discontinue use.
Once the unit is turned off, both heat switches may remain in any
position and will have no power. They will continue to have the
same set functions when the heater is turned back on. Heater
should be unplugged when not in use.
IMPORTANT SAFETY FEATURES
The heater is equipped with an automatic overheat protection
device located inside the body of the heater. If the heater grille
is obstructed, or if the heater gets too hot for any reason, the
automatic overheat protection device will turn the heater off.
To reset the heater, simply turn power off and unplug the heater
for 10 minutes until it cools down and you may plug the heater
in and restart the heater. Be sure that the heater is on a smooth
level surface with no obstructions.
Safety Tip-Over Switch is built-in to automatically turn off the
heater if it tips over. To resume heater functions, simply stand
heater upright on a level surface and follow user operation
instructions.
LEG ASSEMBLY
Simple assembly is required if the legs
of your heater arrive unassembeled.
Using a phillips screwdriver, thread
three screws through the holes in each
leg as illustrated in Fig. 1 and tighten
them down counter-clockwise onto the
underside of the heater. Please note:
extra screws are provided, you may
have some left over after assembly.
SETTING THE THERMOSTAT
After heater has been turned on and the room has reached
the desired temperature, slowly rotate the thermostat knob
counter-clockwise
until the heater shuts off (you should
hear a faint "click"). By leaving the thermostat at this setting
it will automatically maintain this temperature. To lower the
temperature, rotate the knob further
counter-clockwise
towards
the LOW
(—)
position. To raise the temperature, rotate the
thermostat knob clockwise towards the HIGH
(
+
)
position.
Fig. 1
