www.desatech.com
111417-01B
12
INSTALLING LOGS
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
CAUTION: After installa-
tion and periodically thereafter,
check to ensure that no flame
comes in contact with any log.
With the heater set to HI, check
to see if flames contact any log. If
so, reposition logs according to
the log installation instructions
in this manual. Flames contact-
ing logs will create soot.
It is very important to install the logs exactly as
instructed. Do not modify logs. Only use logs
supplied with heater.
Place one-piece log set on grate to fit as illustrated
in Figure 11. Make sure log sits flat on firebox floor
(see Figure 11).
IMPORTANT:
Make sure log does not cover any
burner ports (see Figure 12).
INSTALLATION
Continued
O
F
F
P
IL
OT
O
N
H
I
L
O
Figure 11 - Installing One-Piece Log Set
One
Piece
Log Set
Firebox Floor
Figure 12 - Installing One-Piece Log set
(Top View)
One Piece
Log Set
Burner Ports
INSTALLING OPTIONAL BLOWER
ACCESSORY GA3750
Tools required: Phillips screwdriver
NOTICE: Shut off gas heater
during the following blower
installation.
1. Remove 2 screws from rear tabs on top trim.
Pull trim forward to remove (see Figure 13).
2. Remove top panel of stove by removing three
screws from under top lip on each side of stove
(see Figure 13).
3. Facing front of stove, carefully slide top panel
forward until it is completely removed from
stove (see Figure 14).
Figure 13 - Removing Stove Top Panel
O
F
F
P
IL
OT
O
N
H
I
L
O
Top Trim
Top Panel
Screws
Figure 14 - Installing Bushing
Bushing
