~ 6 ~
Helpful Tips:
1)
If heater will not turn on,
check
main power switch
2)
Check air filter, clean as needed
3)
If your room has minimal heat loss, and is closed off to cooler areas you may be able to reduce the cost
of operation by setting the heater to
low
after the room has reached a comfortable temperature.
4)
If remote is lost you can still operate the heater manually.
5)
Do
not
drag your heater across the room by pulling it by the cord. Stow cord on cord wrap when not in
use.
6)
Use the timer to turn off your heater and save energy
7)
Cool Down
feature: When the thermostat cycles “off” or when you turn the unit off the fan will
continue to run for a few moments to finish distributing the heat and to cool down the heaters heating
elements.
WARNING!
Do not use this product if any part has been under water
.
TROUBLE SHOOTING
PROBLEM
CORRECTIVE ACTION
1. Heater does not blow warm air
a. The room temperature is higher than the thermostat setting.
b. Check to be sure unit is on high setting.
c. If the power button on the front of the heater is red but the heater is
not operating the safety overheat function may have been triggered. Try
pressing the power button. If the heater does not turn on, clear any
obstructions from front and rear of unit that may have caused internal
overheating. Allow the heater to cool for approximately 10 minutes and
then press the power button again.
2. No Power to heater
a. Check circuit breaker, reset as needed or plug into different outlet.
b. Make sure main switch on rear of unit is switched to on position.
c. Over heat safety control activated. Remove blockage from filter and
around heater. Unplug heater for 10 to 20 minutes. Unit should then
operate normally.
d. Call customer service at 1-814-643-1775 or visit us at
www.worldmkting.com
