21
ASSEMBLING LOGS
WARNING:
Failure to position the parts in accordance with these diagrams or failure to use only parts
specifically approved with this heater may result in property damage or personal injury.
CAUTION:
After installation and peridically thereafter, check to ensure that no yellow flame comes in
contact with any log. With the heater set to High, check to see if yellow flames contact any log. If so,
reposition logs according to the log installation instructions in this manual. Yellow flames contacting
logs will create soot.
It is very important to install the logs exactly
as instructed. Do not modify logs; use only logs
supplied with heater. Each log is marked with a
number, and this number will help you identify
each log during installation.
Provided Logs: 6
Fig. 19 - Installing Log #1 Fig. 20 - Installing Log #2 Fig. 21 - Installing Log #3
1. Insert log #1 onto pins in
rear grate base.
2. Insert log #2 onto pins in
middle grate base.
3. Place log #3 onto the
front grate. Make sure the
recessed areas on the log
match up with the grate,
and the log is centered on
grate.
Fig. 22 - Installing Log #4 Fig. 23 - Installing Log #5 Fig. 24 - Installing Log #6
4. Place log #4 so its pin
fits into the hole on the top
left recessed areas of log
#2.
5. Place log #5 so it is resting in
the top middle recessed areas
of log #1 and its pin fits in the
hole on the top of log #2 only
(it should NOT be touching log
#3), and the front edge does no
over hang log #2.
6. Place log #6 so its pin
fits in the hole on the top
right recessed areas of log
#2.
1
2
3
4
5
6
1
2 3 4
5
6
