15
105442
OWNER’S MANUAL
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
INSTALLING LOGS
It is very important to install the logs exactly
as instructed. Do not modify logs. Only use
logs supplied with heater.
Place one-piece log set on grate to fit as
illustrated in Figure 26. Make sure back
section of log set is seated into “U”-shaped
cutout in center of chassis (see Figure 26).
IMPORTANT:
Make sure log does not cover
any burner ports (see Figure 27).
CAUTION: After installation
and periodically thereafter, check
to ensure that no flame comes in
contact with any log. With the
heater set to High, check to see if
flames contact any log. If so, re-
position logs according to the
log installation instructions in this
manual. Flames contacting logs
will create soot.
Figure 26 - Installing One-Piece Log Set
AUT
O
OFF
ON
One Piece Log Set
Burner
"U"-shaped
Cutout in
Chassis
Chassis
Figure 27 - Installing One-Piece Log set
(Top View)
One Piece Log Set
Burner
Ports
OPTIONAL WIRELESS HAND-
HELD REMOTE CONTROL
ACCESSORIES
(CGHRC & CGHRCT Series)
Installing Receiver
1.
Disconnect switch wires from the con-
trol valve.
2.
Remove screws and nuts.
3.
Remove switch plate (see Figure 28).
Discard after removing.
4.
Install remote receiver unit onto gas log
heater base using clips (2) and insulat-
ing washers provided.
5.
Push clips firmly into place (see Fig-
ure 29).
6.
Connect wires as shown in Figure 30.
INSTALLATION
Continued
Figure 28 - Switch Plate and Wiring
Harness (Switch Plate and Orientation
May Vary Depending On Model)
Front
Back
Wires
Nut
Nut
Screw
Front
Front
Back
Figure 29 - Installing Remote Receiver
Insulating Washers
Remote
Receiver
Mounting
Clips
Back
Back
INSTALLING WIRELESS
REMOTE CONTROL
ACCESSORY
Two 9-volt alkaline batteries (not included)
are required to operate this heater with the
wireless hand held remote control set. One
battery must be installed in the receiver and
one in the hand-held remote control unit.
Note:
Only use alkaline batteries.
Installing 9-Volt Battery in
Receiver
1.
Locate back of receiver under front
burner of heater.
2.
Locate the battery clip mounted on the
back of the receiver.
3.
Slide a 9-volt battery through the clip.
4.
Attach the terminal wires to the battery.
Figure 31 - Installing Receiver on the
Back of the Base
Figure 30 - Connecting Wires
Red Wire From
Receiver
Valve
White Wire
From Receiver
Front
Battery
Clip
9-Volt
Battery
Receiver
Terminal
Wires
Continued