CB081A-CB143A / CBE103A-CBE143A Series
Installation and Operation Instruction Manual
13
www.coastair-ac.com
Owner’s Manual -
Room Air Conditioner with R-410A BG-P/BG-M/BGE-M Series
12
Owner’s Manual
Room Air Conditioner with R-410A
Heat Controller
13
INSTALLATION INSTRUCTIONS
W a l l S l e e v e B r a n d s :
# 6 W h i r l p o o l 1 7 D e e p
1 . R e m o v e e x i s t i n g r e a r g r i l l e a s s h o w n o n P a g e
6 o f t h i s m a n u a l a n d r e p l a c e w i t h p r o v i d e d
l o u v e r e d r e a r p a n e l . I n s t a l l a s s h o w n h e r e .
N O T E :
Y o u m a y n e e d t o d r i l l h o l e s i n f l a n g e o f
e x i s t i n g s l e e v e t o m a t c h n e w r e a r g r i l l e .
1
8
/
2 .
C u t ( 2 ) 1 7 Ta p e r e d S p a c e r B l o c k s a s s h o w n
b e l o w i n t o t w o p i e c e s .
3 . I n s t a l l 1 3 s e c t i o n t o t h e f l o o r o f t h e s l e e v e a s
s h o w n . T h i s h e l p s i n d u c e a r e a r w a r d s l o p o n t h e
u n i t .
4 . A t t a c h ( 1 ) 1 x 3 / 8 x 2 5 l o n g s e a l i n t h e c e n t e r
a t t h e t o p o f t h e s l e e v e . R e m o v e t h e b a c k i n g
p a p e r a n d p r e s s i n t o p o s i t i o n .
5 . A t t a c h ( 2 ) 1 x 3 / 8 x 1 4 s e a l s t o t h e l e f t a n d
r i g h t s i d e s o f t h e s l e e v e .
6 . C u t ( 2 ) 1 x 3 / 8 x 2 5 l o n g s e a l s t o 1 4 l o n g
a n d a t t a c h i t t o t h e v e r t i c a l s e c t i o n s o f t h e r e a r
g r i l l e a s s h o w n .
7 . C e n t e r u n i t a n d g e n t l y s l i d e u n i t i n t o s l e e v e .
8 . B e f o r e s l i d i n g a l l - t h e - w a y b a c k , r e m o v e 2 n d
s c r e w f r o m f r o n t o n l e f t s i d e o f u n i t .
9 . R e m o v e t h e p l a s t i c w a s h e r f r o m t h e s c r e w.
1 0 . S c r e w a n d a t t a c h t h e o t h e r e n d o f t h e g r o u n d
w i r e t o t h e u n i t a s s h o w n i n p i c t u r e . M a k e s u r e
t h a t t h e t o o t h e d w a s h e r i s a g a i n s t t h e c a b i n e t .
1 1 . S l i d e t h e u n i t c o m p l e t e l y t o t h e r e a r t o e n s u r e
a g o o d s e a l , m a k i n g s u r e t h e g r o u n d w i r e d o e s
n o t b e c o m e t a n g l e d .
1 2 . S e a l & F r a m e t h e u n i t a s d e s c r i b e d o n p a g e 1 7 .
3
/
4
1 7
T a p e r e d S p a c e r B l o c k
1
P r o t e c t i o n P a p e r
B a c k i n g
C u t H e r e
1 3
5
4
4
4
4
4
3
8
3
8
1 2
3. Install 13” section to the floor of the sleeve as
shown. This helps induce a rearward slope on the
unit.
4. Attach (1) 1” x 3/8” x 25” long seal in the center at
the top of the sleeve. Remove the backing paper and
press into position.
5. Attach (2) 1” x 3/8” x 14” seals to the left and right
sides of the sleeve.
6. Cut (2) 1” x 3/8” x 25” long seals to 14” long and
attach it to the vertical sections of the rear grille as
shown.
7. Center unit and gently slide unit into sleeve.
8. Before sliding all-the-way back, remove 2nd screw
from front on left side of unit.
9. Remove the plastic washer from the screw.
10. Screw and attach the other end of the ground wire
to the unit as shown in picture. Make sure that the
toothed washer is against the cabinet.
11. Slide the unit completely to the rear to ensure a good
seal, making sure the ground wire does not become
tangled.
#6 Whirlpool - 17-1/8” Deep
1. Remove existing rear grille as shown on Page 6 of
this manual and replace with provided louvered rear
panel. Install as shown here.
NOTE:
you may need to drill holes in flange of
existing sleeve to match new rear grille.
2. Cut (2) 17” Tapered Spacer Blocks as shown
below into two pieces.
12. Seal & Frame the unit as described on page 17.
13. If you have difficulty with mounting the grill to the sleeve,
follow the instructions for direct mounting on Page 16.
