IOM - BALL CHECK VALVES, UNIWAT® 3240/3141
©COMEV
AL
V
A
L
VE SYSTEMS
T
e
chnical Dept. Ref. IOM-BALL
CHECK V
A
L
VES, UNIW
A
T® 3240/3141 - Ed.16/07
Comeval V
alve Systems reserves the right to alter any technical data contained in this Manual without prior notice. Regularly u
pdated data on www
.comeval.es
4.5 Marking/nameplate
Nameplate description of the valve:
4.6 CE marking. Intended use acc. to PED
5. INSTALLATION
5.1 General remarks on installation
The following points should be taken into account in addition to the general principles governing installation work:
ATTENTION!
- Before installation, make sure previous chapters are thoroughly followed.
- Ensure safe access and working conditions for proper performance.
- Observe all applicable safety measures during installation.
- Remove fl ange covers or any other remaining packing/storage protection if present.
- Lay pipelines such that damaging transverse, bending and torsional forces are avoided.
- Protect valves from dirt during construction work. The interior of the valve and the pipeline must be free of foreign
particles.
- Protect the valve soft parts from heating caused by welding works at the plant during commissioning.
- Avoid mechanical damage to the seat area.
- The valve is unidirectional. Follow the arrow in the body for installation. The valve can be installed either in vertical
pipelines with normal fl ow upwards or in horizontal pipelines with cover upwards to allow proper working of the inside ball.
- Attention to utilization under low reverse pressure at ball closure, specially in the case of horizontal assembly,
since this can lead to leakage in the reverse fl ow direction.
- There is a crushing hazard between the ball and the body. Ensure the ball is in rest position in case a hand is
introduced inside the valve.
- When installing the valve, there is a crushing hazard between valve and pipe system. Mind the hands to avoid it.
Page 3
Mark
Description
Manufacturer logo
PED 2014/68/EU
Directive 2014/68/EU
SEP
Sound Engineering Practice
www.comeval.es
Website of manufacturer
UNIWAT®
Brand
3240/3141
Valve code
BALL
Ball lining material (EPDM, NBR)
Y.VV
Manufacturing year (Y.16 = 2016)
ZZZZZ-N
Batch / Serial no.
TS
Min. / Max. temperature
PN
Nominal Pressure (max. pressure in bar)
DN
Nominal Diameter
PS
DN
150
200-300
10
16
Out of scope
Liquids of group 2* compatible with materials of construction,
acc. to Directive 2014/68/EU, Annex II table 9 up to category I
* Classifi cation of fl uids group 2 acc. to Directive 2014/68/EU, Article 13.
Check valve selection, material compatibility, pressure and tempe-
rature limits and other essential parameters. Ensure proper safety
devices/measures are implemented to prevent exceeding intended
use of the product. Contact the manufacturer for advice in case of
pressure tests exceeding the intended use. Refer to Data Sheet
and consult the manufacturer for further information.
