Specifications;
• Frequency
Transmit 3.5 ~ 54MHz / Receive 2.0 ~ 90MHz
Recommend antenna coupler combination
• Max. Power 200 Watts ( SSB )
It is based on the power at the time of the intermittent transmit.
• Impedance 50 ohms
• V.SWR
Less than 1.5 : 1 typical
• Connector
SO-239
• Max. Length
8.4 ft ( 2.56 m ) / Max. Height : 2.16 ft ( 0.66 m )
• Weight
5.2 Ib ( 2.36 Kg )
• Wind survival 89.5 mile/Hr ( 144 Km/Hr )
• Mast size range 1.18 -2.8 in ( 3.0 ~7.2 cm )
Representative frequency characteristic figure;
Warning;
• Before you install your antenna, select the most available open site away from electric
power lines and telephone lines. To get the maximum performance from your antenna.
• Be sure to wear a safety hat, safety belt in case of a high behavior industry so that drop
accident desperation may be prevention. An antenna should fail down and drop, and
install it in the location not to give a person and a building harm.
Assembling;
1. Thrust a top element in the fitting screw hole in the top of Pipe (2), and fasten a fixed
Lock nut.
2. Face a red seal side toward the bottom, and install an top element with the reduction coil
in the same way.
3. Loosen and fix a Hexagon head screws (M6 X 8).
4. Use a U bolt, nut for your pole and so on, and fix an antenna itself.
5. Connect your 50 ohms coaxial cable to the female connector of the matching section, and
connect it.
6. Confirm Standing-Wave Ratio value Less than 1.5
Use an antenna coupler with 3.5~ 14-MHz together.
7. Use the supplied self-amalgamating tape to waterproof the connector.
make it waterproof.
*
Frequency can be tuned in the amount of insertion of Pipe (2) exactly.