- 3 -
2)
Battery installation
unscrew the four screws at the corners
of the Batteries holder case and
remove the cover
depending on the required life (see
table above), insert into the Batteries
holder one or two a 3.6V lithium
batteries (of the same type and
manufacturer) with polarity as shown
on figure. Push the battery against
the spring of negative contact and then
release it. Display of the transducer
must light up within 10 seconds and
the transducer will start working.
screw the batteries holder cover. Make sure that the contact surfaces of gasket are free of dirt.
3)
Assembly and fixing of the assembly
screw the transducer onto the holder
posts (1) with the supplied M4 screws
screw all the assembly on the selected
measuring place (2). Observe the
installation instructions and location
rules in the transducer manual.
Depending on the type of material on
which the entire assembly will be
mounted, use two suitable 4 mm
diameter screws.
if, for space reasons, it is preferable to
arrange both devices side by side,
remove the metal posts and montage
plate from the batteries holder and
screw the holder to the left side of the
intended
transducer
position.
Depending on the type of material on
which the entire assembly will be
mounted, use four suitable 4 mm
diameter screws.