Comet IHC3L1200M, Owner'S Manual

Page: 5 / 9

3
PART FIGURE
ASSEMBLY
Front enclosure
Power switch
Front grille
Top cover
Swing switch
Reflector
Rear enclosure
NO.
Description
1
2
3
4
5
6
7
Base plate
Heating tube
8
9
1
2
3
4
5
6
7
8
9
Assemble the main body of the heater and the base plate as follows:
1. Remove the butterfly nuts from the bottom of the main unit.
2. Place the main unit on a flat surface with the heater elements uppermost.
3. Fit the base plate to the bottom of the main unit. Match the projections on
the main unit with the cut outs in the base plate.
4. Fit the butterfly nuts through the base plate and screw them firmly into the
bottom of the main unit.
5. Pass the mains cord through the cord guide channel and fit the guide
cover.
OPERATING INSTRUCTION
1. Insert the plug into a suitable socket.
2. Ensure that the unit is placed on a firm level surface. The unit may not
operate if it is placed on an uneven surface, as the tip-over switch may not
operate.
3. Press the Power switch to the ON position. The upper and centre elements
will operate. The remaining tube can be switched on by pressing the 1200W
switch for full power.
4. Press the Oscillation switch to activate the oscillating feature of the main
unit.
5. After use, turn off all the switches and remove the main plug from the wall
outlet.