background image

          
           GWD 910 / 915

 Wireless Microphone System Owner’s Manual 

 

7

System Overview 

 

Wireless Microphone   GWD915T/910T 

        

 

      

 

 

Battery Selection and Installation  

 

The GWD915/910 wireless microphone is 
powered by a rechargeable lithium-ion battery.  
The wireless microphone housing is designed to 
prevent incorrect installation of the battery.  Do not 
force the battery in to the housing.  Reversed 
batteries may cause damage to the wireless 
microphone.  The battery compartment is located 
at the bottom of the wireless microphone.  Slide off 
the battery cover and remove the silicon seal, at 
this point the battery is free to slide out. 

 

Transmitting Antenna 

 

The GWD915/910 Wireless Microphone includes a 
flexible antenna, which is package separately to 
prevent damage.  Remove the antenna from the 
package and tighten the antenna to the wireless 
microphone. For best result, allow the antenna to 
extent fully.  If the signal is marginal, please 
experiment with different wireless microphone 
position on your body.  Do not attempt to remove, 
replace or change the length of the transmitting 
antenna, which might result in damage of the 
audio system and may violate FCC regulation 

 

Wireless Microphone Contact 

 

The wireless microphone contact is used to 
synchronize the frequency of the wireless 
microphone and the receiver.  It is also the contact 
for the battery charger. 
 
 
 
 
 

Microphone special function note:   
 

Special OOR Mode:   Turn OFF Buzzer and Vibrate Alter to avoid the police become 

shooting target when he chasing suspects and running out of 
radio range (OOR) -- (Use Control command) 

Suspend Enable:  When microphone out of radio range or police off duty over 3 

hours, Microphone goes into suspend to save Battery Power. 

Suspend wake up: 1. Press microphone REC Button (Big) direct to On Air (Record). 
 

2. To sync with Receiver or contact the charger again. 

OAD (Over Air Download Program): Auto overwrites Mic. compatible firmware when 

sync with incompatible Receiver. (All LED blinking around 
60Sec then Beep 3 times to finish OAD process) 

** During OAD can’t move out battery or to sync, but it can press REC Button** 

          
           GWD 910 / 915

 Wireless Microphone System Owner’s Manual 

 

8

System Overview 

 

APL (Auto Police Location)

 

Body GPS Wireless Microphone / GWD915T  

 

 

 

„

       APL (Automatic Police Location) Function: The Body GPS Mic. can send police real 

time location and body motion (walking, running, lying) from 2,000~3,000 feet to patrol 
car and PD when police in emergency or chasing suspects. 

„

 

 The PD can use dispatch or mapping system share the location coordinates and 

body motion to other patrol car for quickly support and rescue. 

„

       When police walking out of patrol hit or attacked by car or suspect, also police 

suddenly running to chase suspect, the Body GPS microphone can auto trigger 
recording and send back location to PD for quickly support and rescue. 

 

GPS Location Data Output Rule and Power Mode: 

 

 

1. When Police moving over 10M (30 feet) - output one coordinate. 

 

 

2. Moving in 10M (30 feet) - Every 1 minute output one coordinate. 

 

Continue Power Mode:

 Continue tracking satellites after 3D fixed (

High Accuracy

)  

 

Saving

 

Power Mode:

 Every time GPS 3D fixed, the GPS go to sleep for 10 seconds 

then wake up for satellites acquisition until the GPS 3D fixed again.

 

Summary of Contents for GWD-915T







Reviews: