IE-COM-D0221-05
11
Actual selected sensor type is displayed - symbols
ni
for sensor
Ni1000/6180ppm or
Pt
for sensor Pt1000/3850ppm. If setting of the
instrument does not match the connected RTD probe type, displayed
temperature readings are not correct. It is necessary to set instrument for
connected probe type from the PC program. The setting is enabled only if
logging is not started.
Display refresh mode is indicated. In the FAST mode refreshment is
fastest with regular interval approximately 0.7 s. In the dynamic refresh
mode (DYN.) each 15 s refresh interval of display is doubled to maximum
5 s if measured values are stable. If measured values change, refresh
interval decreases to approximately 0.7 s. This dynamic mode prolongs
battery life significantly. Select the desired mode by ENTER key. Notice:
if battery voltage is low, the FAST mode is out of operation to reduce
current consumption independently on this selection.
Each pressing of ENTER key causes displaying information on storing
interval, actual logging mode (MODE), memory occupation (MEMO - in
automatic logging mode memory occupation in % is displayed, in manual
mode the number of logged values is displayed) and service information
on software version (upper LCD line) together with instrument
configuration on the LCD lower line.
Alarm indication and setting
It is possible to set lower and upper limit for each measured quantity.
Breaking of the limit is indicated by blinking of the appropriate value
on the display. If a new alarm was indicated (i.e. it was not active in
the previous measurement), display starts to display the value out of
limits. If at least one alarm is active, audio indication can be activated,
if menu AUDI "On" is selected (see setting described above). Alarm
activation of each value can be disabled by setting lower alarm limit
of the desired value up to its maximum. This is indicated by OFF
reading at the position of numeric value. Value of upper limit of the
same alarm is indifferent.
To set alarms press MENU key, select ALAR from menu items and
confirm by pressing ENTER key.
