27
2
1
3
4
5
1
2
ON
1 2 3 4 6 7
5
8
cod. 114
2
S1 S2
1
3
3
2
S1 S2
1
2
3
5
6
1
2
3
3
1
2
1
4
Replacing the audio module with programming restore
backup
Take note of the DIP-switch
settings
NEW
OLD
1.
Enter programming mode by moving
S2
DIP-switch
upwards
» the red “system busy” LED flashes for the duration of
the procedure
2.
Set special programming
114
to import all the
programming settings
3.
Press the confirm programming button
» the green “lock-release” LED will start flashing
» at the end of the backup (approx. 30 sec.):
» the green “lock-release” LED switches off
» the green “audio enabled” LED comes on for a
few seconds.
1.
Exit programming mode by moving the
S2
DIP-switch
downwards
» the red “system busy” LED switches off
2.
Reset the configuration of the DIP-switches
3.
Reattach the front panel
If the audio or audio/video module is replaced, the following instructions must be observed.
The procedure should be completed within one hour of removal of the old module.
Summary of Contents for Simplebus2 UT2010
Page 1: ...Passion Technology Design EN TECHNICAL MANUAL Simplebus2 Ultra audio module Art UT2010...
Page 8: ...8 2 1 2 UP 5 3 4 165 cm 130 cm 1 Flush mounted installation Optional BLACK RED Optional...
Page 11: ...11 165 cm 130 cm 2 UP 5 3 4 UP 1 2 3 1 Wall mounted installation Optional Optional BLACK RED...
