26
2
1
LL
2
1
4
S1 S2
5
6
S1 S2
3
Twilight sensor
Camera LED lighting and button backlighting management
The twilight sensor is in AUTO mode by default: the camera and button LEDs light up at night and switch
off during the day. To change the setting to ON (LEDs always on) or OFF (LEDs always off), proceed as
follows:
NOTE: when the OFF and AUTO lighting modes are active, every time the entrance panel is powered, the
buttons light up for the duration of the start-up phase (10 seconds maximum).
In AUTO mode the twilight sensor checks the ambient light level every 9 minutes; if the measured values
exceed the specified minimum/maximum thresholds, it is activated/deactivated accordingly.
When programming is
complete, make sure the
button configuration is
correct (single/dual), see
Take note of the DIP-switch
settings
Set the desired mode for the camera
(A
) or button
(B)
LEDs
and press the confirm button
Reset the configuration of the
DIP-switches
OFF
ON
AUTO
(default)
ON
1 2 3 4 6 7
5
8
cod. 168
ON
1 2 3 4 6 7
5
8
cod. 169
ON
1 2 3 4 6 7
5
8
cod. 170
OFF
ON
AUTO
(default)
ON
1 2 3 4 6 7
5
8
cod. 158
cod. 159
ON
1 2 3 4 6 7
5
8
ON
1 2 3 4 6 7
5
8
cod. 160
