MT SB 01
MT SB 01
31
E
N
This function can be used to divert calls for the
switchboard to local or remote telephones.
To activate this function, press and hold the DAY/
NIGHT key
for at least 3 sec., until the display
shows:
FOLLOW ME
ACTIVE
To disable it, repeat the procedure so that the initial
screen appears on the display:
A
D
(_ _) 14:40
WED 12/03/10
Once a call has been made, the switchboard will
ring until the remote device begins communicating;
the call can be answered from the switchboard by
cancelling the “Follow me” function.
CAUTION!
To use this function, telephone switchboard
Art. 2906 and interface Art. 2912 must be fitted.
Contact your usual installer.
This function can only activated for the
switchboard set as secondary (see “C8.3 TYPE
OF SWITCHBOARD”, page 40).
U14 How to activate the “Follow me” function
(available from R.I.006)
The switchboard can receive alarm signals
transmitted by internal units in any operating status
(call or conversation).
When the switchboard receives an alarm:
- an alarm sounds. The signal may be
silenced by
pressing any of the buttons on the switchboard.
- the alarm signal for the first user that activated the
alarm appears on the display:
ALARM (04)
USER 002
the signal
disappears when the internal unit answers
the switchboard call (to make the call, press
),
or when the switchboard operator forces a deletion
process using the
CANC key.
If several alarm situations occur simultaneously,
an alarm code is created using the same methods
as described in the section “U6 HOW TO CALL
AN INTERNAL UNIT LISTED IN THE CALL LOG”
page 28, and only the number of alarms recorded
will appear on the display (max. 10).
When a call is received from an external or internal
unit, the switchboard exits alarm status so that the
incoming call can be dealt with correctly. Once the
call has been dealt with, alarm status is restored.
U15 Alarm signalling
(available from R.I.006)
Actuators can be activated in standby mode and
during conversation with an external unit.
To activate the actuator:
- press
, you will be asked to enter the code to
activate a specific actuator. If there is no code a
generic actuator will be activated;
ACTUATOR
CODE:
- to confirm actuator activation, press
.
CAUTION!
To use this function, there must be an external unit
and actuators Art. 1256. Contact your usual installer.
U16 How to activate an additional relay
(e.g. to activate the following independently and with
a specific command: lights, CCTV alarm contacts,
driveway gates, entrances without external units or
other devices) (available from R.I.006)
When calling a secondary switchboard, the main
switchboard may use one of the 3 following methods:
• enter the switchboard number (e.g. 005 240) and
press
:
USER: 005 240
TO CALL
• scroll through the directory using the
keys until
the name is displayed and press
:
SWITCHBOARD
005
CODE: 005 240
• press the corresponding
speed number (see “I4-
RECORDING SPEED NUMBER” page 36).
- If the call has taken place correctly:
CALLING
USER 005 240
- if the call has not taken place correctly:
USER 005 240
NOT AVAILABLE
- if the system is busy:
BUSY
USER
U17 How to call a secondary switchboard from a
main switchboard (available from R.I.006)
Summary of Contents for MT SB 01
Page 94: ...GROUP S p A MT SB 01 90 ...
Page 95: ...MT SB 01 MT SB 01 91 ...
