5
Legend: buttons and indicator LEDs
f
Press the desired button once to activate the associated function
Wait for approximately 1 sec. before pressing the same button again. Pressing the same button several times in
quick succession will cancel the command.
Description of buttons
Audio activation
f
Press the button to answer an incoming call.
Lock-release command
(default)
*
[programmable]
f
Press the key to activate the corresponding door
lock.
Actuator control
(default)
*
[programmable]
f
Press the key to activate the corresponding
relay.
Secondary switchboard
(default)
*
[programmable]
f
Press the key to call the secondary switchboard.
Silent mode (Privacy)
f
Press the key to enable silencing of the ringtone
on receipt of a call from the external unit and
from the switchboard.
* To change the default settings and to program other
functions, please refer to paragraphs
Indicator LED description
steady on (in call): communication in progress
steady on (in standby):
Automatic answer (hands-
free)
mode enabled
continuous flashing: incoming call
slow flashing: door open
1 flash after pressing button: door open confirmed
continuous flashing: incoming call
steady on: silent (Privacy) mode enabled
3 flashes (every 5 sec.): door opening upon call
function (Doctor) enabled
continuous flashing: device in programming mode
4 flashes: system busy
Pressing and holding keys
(Disabled by default from firmware version 1.2.0)
Pressing and holding keys adds further functions to the door-entry phone.
Carry out the procedure described below to enable - or disable, depending on the factory setting - the press and
hold feature:
√
Door-entry phone in standby.
1.
Take note of the S2 DIP-switch settings.
2.
Enter programming mode by setting S2 DIP-switches 1, 3, 5 to ON.
» the LED flashes
3.
Press to enable (or press to disable).
4.
Make sure the
key flashes 4 times and the confirmation tone is emitted.
5.
Restore the initial configuration of the S2 DIP-switches.
» LED switches off
Once the procedure is complete, you will be able to enable the following functions:
Automatic lock-release on receipt of call (Doctor mode)
Automatic activation of the Lock-release relay on receipt of a call originating from the external unit.
f
Press and hold (4 sec.) the programmed button to enable/disable the function.
Automatic Answer (Hands-Free mode)
Automatic audio opening on receipt of a call.
f
Press and hold (5 sec.) the audio activation button to enable/disable the function.
»
ENABLING: + LED STEADY ON
»
DISABLING:
+ LED OFF
