Comedes BTR 50, Manual, Page: 10 / 21

 Soft underlay (blanket, sleeping mat, towel or similar)
Assembly steps for the BTR 50:
Attention Please note that the device is heavy. To avoid injuries or damage to the device
and objects in the vicinity, the installation should be carried out by 2 persons.
A)
Preparation
a. Remove the dehumidifier from the packaging and check it for damage
b. Check the accessories (mounting set) for completeness.
c. Prepare the tools required for the assembly.
B) Mounting (See Figure 4)
a. Carefully place the device on its front side. Lay a soft surface (blanket, mattress,
towel, etc.) underneath to avoid damage such as scratches.
b. Assemble the transport handle using the 4 stainless steel screws, as shown in Figure
4.
c. Mount the two wheels as shown in Figure 4.
d. Now carefully place the device on its back. Lay a soft surface (blanket, mattress,
towel, etc.) underneath to avoid damage such as scratches.
e. Mount the stand as shown in Figure 4.
f. Return the dehumidifier to an upright position.
Leave the appliance in its final, upright position for at least 24 hours before starting
it up for the first time.
Always operate the appliance in an upright position and do not tilt it during
operation.
Installation Instructions
Operate the device only in rooms with at least 20m².
floor space
 Remove all adhesive tapes that were used for transport securing.
 Check that the device is standing securely on firm, level and dry ground.
 Never install the unit where it may be exposed to the following conditions:
o
Heat sources, such as radiators, heat registers, stoves or other products that
generate heat
o
In an area where oil or water can be splashed.
o
Direct solar radiation
o
Mechanical vibrations or shocks
o
Excessive dust exposure
o
Lack of ventilation, e.g. in a cupboard or bookshelf
o
Uneven surface
 Make sure that the power outlet is equipped with an RCD (ground fault circuit interrupter).
If you are not sure whether this is the case, you can ask your electrician or use
a personal protection plug (available at a hardware store).
 To save power and avoid potential hazards, disconnect the unit when not in use.
 Keep at least 50cm distance around the device to walls and objects. Make sure that the air
outlet is free and that there are no curtains or textiles above it.