Parameter Symbol
Description
Parameters of Level L3
Input Type
inP
Type of signal that can be connected to the device input
Unit
unit
Temperature measurement unit
Point Position
Pnt
Display decimal point position
Input Low
ILo
Display value at low limit of the linear input range
Input High
IHi
Display value at high limit of the linear input range
Input Correction
Icr
Constant to be added to the measured input value
Address
Addr
Device address
Baud Rate
bAud
Serial interface rate
Gradient
GrAd
Maximum admissible input change for 120 ms sampling period
Filter Time
\t
Relative time constant of the input filter
Filter Band
\b
Zone around the measured value, within which the filter is active
SP Limit Low
%[L
Set-point low limit
SP Limit High
%[H
Set-point high limit
Direction 1
diR1
Control action direction of output
K1
Direction 2
diR2
Control action direction of output
K2
Parameters of Level L2
+Differential 1
[e1
Relay switching differential over set point for output
K1
-Differential 1
me1
Relay switching differential under set point for output
K1
Time On 1
ym1
ON duration of pulsed output
K1
Time Off 1
y\1
OFF duration of pulsed output
K1
Hold 1
HLe1
Holds the output
K1
reaction
The same 5 parameters, but with index
2
-
for output
K2
Parameters of Level L1
Set Point 1
%[1
Set-point value of output
K1
Set Point 2
%[2
Set-point value of output
K2
