Approvals
This device complies with Part 15 of the FCC rules. Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet or a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for
help.
The user is cautioned that changes and modifications made to
the equipment without approval of manufacturer could void the
users authority to operate this equipment.
Change to Conforms to UL STDS 1023
Mounting
Mount the keypad battery door to the wall in the
desired location using the included mounting screws
and anchors. Align the keypad to battery door and
snap keypad onto battery door. (XFINITY
®
HOME
technicians MUST use screws to install keypad).
Status
There is one system status LED located at the bottom
of the Security Keypad. Different colors represent the
following system status:
Green:
Ready/Not Armed
Red:
Armed
:
Not Ready
Arming
Arm Stay Button
Press this button and enter your 4 digit
security code to arm in stay mode.
Arm Away Button
Press this button and enter your 4 digit
security code to arm in away mode.
Arm Night Button
Press this button and enter your 4 digit
security code to arm in night mode.
Replacing Batteries
1. View battery level indicator to determine if batteries
need replacement. Battery level indicator will display
when batteries have less than 60 days of use
remaining.
2. Pull keypad away from wall to remove from battery
door.
3. Remove the old batteries then install AA Lithium
batteries.
a. Lithium batteries which came with device are not
rechargeable.
4. Align the keypad to battery door and snap keypad
onto battery door.
Weekly Testing
To ensure that your system continues to functioning
as intended, you must test your system weekly.
Please contact your security monitoring company for
instructions on how to test your system.
Controls
Function Buttons
A Button:
Reserved for future use
B Button:
Reserved for future use
Volume Control
There are 5 possible volume levels. To increase the volume,
press and hold the #2 button. To decrease the volume, press
and hold the #5 button. As the volume raises or lowers, there
will be an audible beep signifying that the volume has
changed. Continuing to hold the #2 or #5 button down will
continue to raise or lower the volume.
Door Chime
Toggle Door Chime on/off by pressing and holding the #8
button.
Proximity Detection
The keypad is able to detect the user’s presence within 6
inches. Once detected the keypad will awake and illuminate.
(Lithium batteries do not charge)
residential installation. This equipment generates, uses, and
can radiated radio frequency energy and if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
This device and it's antennas(s) must not be co-located or
operating in conjunction with any other antenna or
transmitter except in accordance with FCC multi-transmitter
product procedures. These limits are designed to provide a
reasonable protection against harmful interference in a
