1
INSTALLER: Leave this manual with your customer upon completion of the installation.
The Wireless Digital Programmable Keypad is a high quality, state of the art product with programming capabilities for four separate entrances. We
believe this to be the finest product available anywhere and fully expect that you will receive many years of excellent service from your new keypad.
Because of the programmable nature of your new keypad it is important to follow the programming instructions carefully. While they may seem a
little complex at first, if you read these instructions carefully with your keypad close by, you should have little problem setting your new system.
TERMS USED IN THIS MANUAL:
WIRELESS DIGITAL
PROGRAMMABLE
KEYPAD
PRODUCT FEATURES
PIN:
Is the Personal Identification Number you choose which will allow
you to operate your door or gate controls. The
Primary PIN
is the PIN
you choose and program the keypad with to operate the door or gate.
After programming, The Primary PIN becomes the only number which
can be used to re-program your system. It is your insurance against
anyone else re-programming your system.
Factory Default:
Refers to settings on your keypad which were made at
the factory.
LED:
Light Emitting Diode, or indicator light on your keypad.
FEATURES OF YOUR NEW KEYPAD:
The Keypad has a number of operating features and indicators to provide
you with information and make its overall use easier.
Factory Default Setting:
Should you ever forget your PIN you can
restore your keypad to the original factory default settings. Once you do
this, however, you must go through the programming steps again. To
restore the factory default setting PUSH 999, PUSH #, PUSH 999,
PUSH #. All codes are now restored to the original factory settings.
Reset/On-Off Switch:
This switch turns the keypad and light system on
allowing you to operate the system as well as to see the keys in the dark.
The keypad will remain lit for 20 seconds after the last key is pressed.
This key is also used to cancel the programming mode if you make a
mistake during the programming process.
Key Press Indicator:
This green LED (see Figure 2) will light
whenever a key is pressed indicating a valid key entry.
Signal Sent Indicator:
This red LED (see Figure 2) will light whenever
a valid PIN is entered indicating that a radio signal was sent to your
garage door or gate operator.
Incorrect Entry Indicator:
Should you ever enter an incorrect PIN
both red and green LED’s will light simultaneously indicating an entry
error. If this should occur please reset the system and enter a valid PIN.
Single Button Mode:
Once you have entered a valid PIN and your door
or gate operator begins to function, the number and letter keys remain
active for 20 seconds. Pressing any one of these keys will send another
signal to your operator, thus allowing you maximum control over your
system. Depending on the operator, each signal you send can cause your
operator to either stop or reverse direction. Please see the operating
instructions that came with your operator to determine how your operator
will react to these inputs.
Low Battery Indicator:
The lighting for your keypad also serves as a
low battery indicator. Should your keypad lights flash on and off it is an
indication that your battery should be changed. If your battery does need
to be replaced, simply open the hatch on the lower right side of your unit
(see Figure #2) by sliding it forward, and remove the battery. Replace
the battery with a standard 9 Volt transistor battery and replace the hatch.
Non-Volatile Memory:
Because your new programmable keypad uses
non-volatile memory it is not necessary to reprogram your unit should your
battery fail. Just replace the battery with a new one and your keypad is ready
to operate again.
ABOUT YOUR KEYPAD
READ THIS MANUAL
CAREFULLY BEFORE
INSTALLATION OR
USE
.
-
Model 104078
