CombiSteel 7476.0136, User Manual

Page: 5 / 19

5
1.3 TESTING
The cooler is shipped ready for use. The temperature control is preset from the factory. As needed, the
temperature control can be adjusted Clock-wise to make the product “Colder”, the control can be adjusted
Counter Clockwise to make the product “Warmer”. We don’t recommend customer to adjust. Because the
regulation too cold Setting can cause the freezing of the products. The best cooling performance is achieved if
the unit is optimally filled and the air circulation inside the unit is unobstructed by the products inside the
refrigerator.
1.4 RESPONSIBILITY OF THE CUSTOMER
Ensure that the electrical outlet is connected effectively to earth (ground), suitable to provide the voltage
indicated on the data plate. Make sure that the cooler is placed on a level surface.
2. TECHNICAL DATA
2.1 MATERIALS AND REFRIGERANTS
Interior or exterior surfaces that come into contact with the products are made of galvanized steel. Aluminium
or non-toxic plastic materials. The Refrigerant used is approved by government regulations. The type and
quantity of the gas charged, in the refrigeration unit, is indicated on the data plate.
3. INSTALLATION
For safe proper operation, follow the manufacturer´s instructions reported in this section.
3.1 POSITIONING
The cooler must be placed in an adequately ventilated room. Keep away from heat sources, such as radiators or
air conditioning pipes. Allow free air circulation to the refrigerator unit. The ambient temperature must not be
higher than 32°C.
This appliance climate class is 4
Testroom climate
class
Drybulb
temperature °C
Relative humidity
%
Dewpoint °C Water weight in
dry air g/kg
0 20 50 9.3 7.3
1 16 80 12.6 9.1
2 22 65 15.2 10.8
3 25 60 16.7 12
4 30 55 20 14.8
5 40 40 23.9 18.8
6 27 70 21 15.8
7 35 75 30 27.3
3.1.1 Cooler Leveling: To provide the best performance the cooler must remain level.
3.2 ELECTRICAL CONNECTION
WARNING DO NOT USE EXTENSION CORDS
The cooler works on single-phase voltage (220-240V/50Hz) power supply. To switch on the cooler, insert the plug
into the outlet. Ensure that:
The electrical outlet must be provided with an efficient ground, the voltage and the frequency of the electrical
line matches those indicated on the data plate. If unsure about the efficiency of the ground, have your electrical
circuit checked by qualified technician. When the cooler is operating, check that the supply voltage is not
dropping or increasing under/over +10% the rated voltage (187 Volts to 242 Volts). If the light is damaged, it
must be replaced with a same size, power and shape one. and must be replaced by the manufacturer or its
service agent.