CombiSteel 7227.0005, User Manual

Page: 15 / 88

15
www.combisteel.com
Remote Control Sensor:
•
Remote control sensor receives infrared (IR) signal from the remote control. The maximum distance for
IR data transmission is 3 meter (10 ft.) and requires direct line of sight. The transmission distance may
vary depending on temperature and remote control battery condition.
Note: Light settings are independent from other settings (including power-off delay) and lights have to be
manually turned on or off.
USE AND CARE
Troubleshooting
If the range hood or halogen light does not
operate after installation:

Check if the range hood has been plugged in, make
sure that all power has been turned back ON, fused
not blown and all electrical wiring are properly
connected.

Swap out light assembly to working ones to
determine whether it is caused by defective bulbs.
See Replacing the light bulbs on Page 21/22.
The range hood vibrates when the blower is on:

The range hood might not have
The blower or fan seems weak:

Check that the duct sized used is at least 8” or 3-1/4
x 10”. Range hood WILL NOT function efficiently with
insufficient duct size. For example: 10” duct over 8”
hole and loosely secured.

Check if duct is clogged or if damper unit (half-
circular flapper) is not installed correctly or opening
properly. A tight mesh on a side wall cap unit might
also cause restriction to the air flow.
The lights work but the blower is not spinning
at all, is stuck or is rattling.
•
The blower might be jammed or scraping the bottom
•
due to shipping damage. Please contact us
immediately.
The hood is not venting out properly:
•
Make sure the distance between the stove top and
the bottom of the hood is within* 27” and 30” in
distance. *Due to different ceiling height
configurations, recommended height may not be
applicable.
•
Reduce the number of elbows and length of duct
work. Check if all joints are properly connected,
sealed, and taped.
•
Make sure the power is on high speed for heavy
cooking.