4
www.combisteel.com
Installation instructions
This appliance is designed to be free standing only, and should not be recessed or built-in.
Place your unit on a floor that is strong enough to support the unit when it is fully loaded. To level your unit,
adjust the levelling legs at the bottom of the unit.
This appliance is NOT designed to be installed inside of a cabinet where the front is covered by any type
of door.
Allow 7cm of space between the top, back and sides of the unit, which allows the proper air circulation
to cool the compressor and condenser.
Locate the unit away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight
may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient
temperatures may also cause the unit to not perform properly.
Avoid locating the unit in moist areas.
Plug the unit into an exclusive, properly installed grounded wall outlet. Do not under any circumstances cut
or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding
should be directed toward a certified electrician or an authorized service centre.
After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3 hours before placing food
and drinks in the appliance.
Remark: please remember to keep some water in the cabinet to keep the humidity.
For disposal of the appliance
To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. And the disposal should only be done
through public collection points.
For installation, servicing
Appliance should be placed on a horizontal floor and keep the ventilation freely. Don’t try to replace or repair
any components by yourself, ask the service agency for help if necessary.
For handling
Always handle the appliance to avoid any damage.
