4. Remove loops at ends of both shoulder harness straps
from metal harness plate
(fig. k)
.
5. From front of car seat pull shoulder harness straps out of
seat and seat pad
(fig. l)
.
43
(fig. k)
(fig. l)
Metal
Harness
Plate
44
Reassembly of shoulder harness straps and harness shield:
• To prevent ejection in a crash, the sewn loops on the shoulder harness straps MUST be
properly attached to the metal harness plate.
• Harness shield MUST be properly secured at all (4) corners and belts stored inside
harness shield so seat can rotate smoothly from forward-facing to rear-facing position.
• To prevent loose harness and risk of ejection, harness shield MUST be in place during
use.
• To prevent slack in harness and potential ejection in a crash, the shoulder harness straps
must be routed through harness slots at the same height in the pad and seat back.
WARNING -
DEATH or SERIOUS INJURY can occur
a. Attachment of shoulder harness straps.
1. Pull out on shoulder harness strap to make sure it is not twisted.
2. Slide end of shoulder harness strap through harness slots at required height
in seat pad, foam, and seat back. Pull all excess strap through seat back.
3. Check that shoulder harness strap is not twisted.
4. Repeat for other shoulder harness strap.
3
All manuals and user guides at all-guides.com
