Combi NE-YO PLUS, Instruction Manual

Page: 17 / 28

14
Folding the stroller (Figure 3.6)
Slide to release the safety lock of direction as illustrated.
Grip the folding lever and slightly lift up the handle, then press down the handle as
illustration to fold the stroller.
1
2
1 2 3 4
WARNING
: When folding the stroller, please ensure your child and other
children are kept at a safe distance. Please ensure that they are not in contact with
mounting parts and remove all items from the basket before folding the stroller.
Basket (Figure 4.1)
The basket can carry a maximum weight of 5kgs.You can attach and remove it using the
belts and snaps according to step
Detaching the seat cushion(Figure 4.2-4.6)
1
2
3
4
5
6
Release front snaps and elastic bands underneath of the seat, and on both sides of seat.
Remove the shoulder belts from the shoulder belt hooks.
Detach the snap on the seat cushion from the leg support bar
(if the leg support bar is in use)
Pull out crotch belt from seat cushion.
Release both elastic bands from backrest sides.
Pull out shoulder and waist belts from seat cushion.
Release the snaps of band on both cushion sides of the cushion and unwind
from the connections of armrest sides for detachment.
NOTE: To install seat,go in the steps reverse.
WARNING
: Make sure the seat cushion has been correctly attached before use.
Attaching the waist belt(Figure 4.7)
NOTE: Make sure to pull through all waist belt insert outlets(total 4 places)when
attaching the waist belt.
Remove two of insert plastics buckle from the waist belt.
According to the direction of arrow instructions Pull the waist belt through the 4 slits on the
base board with the reverse side(waist belt) facing up.
Re-attach the insert plastic buckle and pull it out through relevant slots of seat cushion.
1
2
3
Adjust shoulder harnesses heights (Figure 4.8)
NOTE: The lowest shoulder harness insert outlet should be used for children under
6 months.
Pull out shoulder harnesses from seat cushion and base seat.
Set the correct slots of shoulder harnesses through on the base seat.
Set correctly the harness shoulder heights and pull it out through relevant slots of seat cushion.
1
2
3
.
EN
.
Attaching the sun canopy (Figure 3.5)
Switch the handle to face rear. Refer to the “Reversing the handle”.
Recline the backrest to the lowest angle. Refer to the “Adjusting the backrest”.
Place the canopy facing the proper direction.
Plug the canopy joint into the canopy holder.
Lift up the backrest, and fasten the canopy snaps.
1
2
3
4
5
Detaching the sun canopy (Figure 3.4)
Pull out the canopy joint end gradually, pull up the canopy away from the holder.