Combi ANGEL WAGON AW Series, Instruction Manual And Inspection Manual, Page: 28 / 32

Combi ANGEL WAGON AW Series Instruction Manual and Inspection Manual
Installation AW3 Series (Forward facing type)
Remove the umbrella ring and the umbrella holder using the Philips
screwdriver and the wrench
Install the umbrella ring following the removal procedure in the reverse order. Install the umbrella holder to the frame.
1 2
Install the umbrella ring at 310 mm from the top of the handle pipe
with a screw and a cap nut using the Phillips screwdriver and the
wrench.
Install the ring facing toward the
back of the seat.
Orient the umbrella holder toward the handle
bar and assemble it where it is in contact with
the frame. The top of the holder should be at
the same level as the upper edge of the frame.
Note: The screw used for the umbrella ring and the one used for the umbrella holder do not have the same length. Pay
attention to use the correct screw for each part.
Phillips
screwdriver
Phillips
screwdriver
Phillips
screwdriver
Phillips
screwdriver
Handle
310 mm
Umbrella ring
Umbrella ring
Umbrella ring
Umbrella
Holder
Umbrella
holder
Wrench
Nut
(attached to
the holder)
Nut
(attached to
the holder)
Cap nut
Cap nut
Wrench
Wrench
Wrench
Screw M6 x 30 mm
(with a plain washer and
a spring washer)
Screw M6 x 30 mm
(with a plain washer and
a spring washer)
Screw M6 x 25 mm
(with a plain washer and
a spring washer)
Screw M6 x 25 mm
(with a plain washer and
a spring washer)
Flange nut
Flange nut
Removal AW4 Series (Rear facing type)
27