ComAp IG-NT, Installation Manual

Page: 65 / 149

IGS-NT Installation Guide
65
7.8.2. Terminals, Inputs and Outputs
Function Terminals Note
Mains voltage L1,L2,L3, (N) 3x120 / 277 Ph-N or 207 / 480 Ph-Ph VAC
(neutral not needed), max 350 / 600VAC*,
CAT III
Bus voltage L1,L2,L3, (N) 3x120 / 277 Ph-N or 207 / 480 Ph-Ph VAC
(neutral not needed), max 350 / 600VAC,
CAT III
Mains current L1k,L1l, L2k,L2l,
L3k,L3l 0 ÷ 5 Amps, max 10 A all time, 150 A for 2
sec
0 ÷ 1 Amp, max 2 Amps all time
Aux current IAk,IAl 0 ÷ 5 Amps, max 10 A all time, 150 A for 2
sec
0 ÷ 1 Amp, max 2 Amps all time
Power supply + , - 8 ÷ 36 VDC
Inputs and outputs
Binary inputs BI1 ÷ BI12 Activation to minus power supply.
Binary outputs BO1 ÷ BO12 Load is connected to plus power supply.
Analog inputs AI1 ÷ AI3 Ohms, mA, Volts sensors
Analog outputs AOUT-, AOUT-COM Configurable analog output, mA, V.
Communication interface
RS232 (1) D SUB9 (male) PC: InteliMonitor, GenConfig or
Modem, GSM modem or
ECU (e.g. Cummins ModBus) or InteliVision
8
RS485 (Display) ** A1,B1,COMR1 Up to 3 IS-Displays (Remote display), up to
3 InteliVision 8 displays (remote display) or
3 InteliVision 5.
RS485 (2) ** A2,B2,COMR2 Redirected RS232 (2)
– see
Basic
settings: RS485(2)conv.
PC: InteliMonitor, GenConfig
or Modem, GSM modem or InteliVision 8
USB
Electrical isolated 2.0 slave PC: InteliMonitor, GenConfig
CAN1 L1,H1,COMC1 Extension modules: IS-AIN, IS-BIN,IGS-
PTM, IGL-RA15, I-AOUT
CAN2 L2,H2,CONC2 Intercontroller (Load&VAR sharing, Power
management), monitoring (IG-IB, I-LB) and
up to 4 InteliVision 8
RJ45 (Ethernet) Ethernet cable Remote monitoring via Ethernet,
InteliMonitor, WebSupervisor and etc…
N
OTE
:
Light blue
– IM-NTC-BB only.
* IG-MTU or IG-MTU-2-1 can be used for three wire systems, systems with separated
Neutral or when galvanic separation between generator or mains voltage and controller is
required.
** When more devices connected to RS485 bias resistor jumpers should be closed only on
one of them.