ComAp IG-NT GC, Reference Manual

Page: 214 / 260

IGS-NT-BC, SW Version 1.2.0,
©ComAp – January 2019
IGS-NT-BC-1.2.0 Reference Guide.PDF
214
N
OTE
:
See an example in the description of the binary input Force value 1 .
Binary input: Force block 1
Related FW 3.0
Description This is one of three binary inputs used for user-defined blocking of protections. If
the input is active, all the protections that have
Protection block type configured as
Force block 1 block type are blocked (i.e. temporarily disabled).
Binary input: Force block 2
Related FW 3.0
Description This is one of three binary inputs used for user-defined blocking of protections. If
the input is active, all the protections that have
Protection block type configured as
Force block 2 block type are blocked (i.e. temporarily disabled).
Binary input: Force block 3
Related FW 3.0
Description This is one of three binary inputs used for user-defined blocking of protections. If
the input is active, all the protections that have
Protection block type configured as
Force block 3 block type are blocked (i.e. temporarily disabled).
Binary input: Lang sel int A
Related FW 3.0
Description This is one of three binary inputs Lang sel int A , Lang sel int B , Lang sel int C ,
used for selecting language of the built-in IG-NT terminal (display). As the IS-NT
does not have built-in terminal, this input is assigned to the terminal (display) #1,
which is supposed to be directly attached to the controller or mounted close to it.
N
OTE
:
Using these inputs for language selection is an option only. If the inputs are not
configured, the language can be selected using the menus on the terminal.
E
NCODING TABLE
L
ANGUAGE INDEX
I
NPUT
A I
NPUT
B I
NPUT
C
0 0 0 0
1 1 0 0
2 0 1 0
3 1 1 0
4 0 0 1
5 1 0 1