11
MACHINE PREPARATION
8.
SOLUTION TANK
Remove the filler cap and check that the solution filter, on the bottom left, is
fitted properly.
9.
DETERGENT SOLUTION
Fill the solution tank with clean water at a temperature no greater than 50
°
C and
add liquid detergent in the proper concentration, following the instructions of the
manufacturer. The formation of excess foam could damage the suction motor, so
use only the minimum amount of detergent necessary. Reassemble the cap.
ATTENTION!
always use low foam detergent. To avoid the
production of foam, before starting to clean, put a minimum quantity
of antifoam liquid into the recovery tank
. Never use pure acid.
10. ASSEMBLING THE BRUSH
1. With the base up, insert the brush and position it in line with the plate
beneath the base.
2. Connect the plug to the power supply.
3. Lower the base, press the brush switch (2), push the man present lever (3)
on the handlebar.
At this point, the brush is fixed.
ATTENTION!
During this operation, check there are no people or
objects near the brush.
2
3
3. Using the knob (1), adjust the height of the splash guard rubber so that it
rests on the floor.
The adjustment should be repeated periodically depending on the wear of the
brush
1
