DANGER:
•
To reduce the risk of fire, electric shocks or injury, please read and follow the safety instructions
and warning indications before using. This appliance has been designed to be safe when it is
used for cleaning in the manner specified. If damage to electrical or mechanical components
is found, the appliance must be repaired at the relative authorised service centre or else at the
manufacturer before use, in order to prevent further damage to the appliance or physical injury
to the user.
• Before connecting the appliance to the electricity socket, make sure the electrical information
on the plate corresponds to that of the mains supply.
The appliance must only be powered
with alternating current and voltage equal to that shown on the serial number plate
.
• The power supply cable outlet must have an earth connection in compliance with the regulatory
standards.
• The cable for connecting to the mains that is supplied with the appliance should be used for
the above-mentioned appliance and not for other appliances.
• Before using, check for any damage on the connection cable and on the power plug.
• If the power cable is damaged it should be replaced by the manufacturer or by its technical
service centre or in any event by a person with similar qualifications in order to prevent any
risks.
• Connect the appliance only to an electrical connection installed by an electrical installer in
conformity with IEC 60364-1.
• Never touch the power plug with wet hands.
• Make sure that the cable to the mains or the extension cable have not been damaged by having
been walked on, crushed, pulled or the like. Protect the cable from heat and from contact with
oils or sharp edges.
• Make sure that the cable connected to the mains or the extension cable have not been damaged
when the scrubbing brush head is used, passing over it with the brushes or rotating discs.
• Regularly check that the cable connecting to the mains is not damaged, for example with
signs of ageing or cracks. If damage is found, the cable should be replaced before using the
appliance again.
• Protection against splashes of water and the mechanical strength need to be ensured also
after any replacement of the joints of the power cable or the extension cable.
• Do not clean the appliance with a hose or a jet of high pressure water (risk of short-circuit or
other electrical faults).
ATTENTION:
• The procedure causes short-term reduction in voltage.
• In unfavourable grid conditions the other appliances could be damaged.
•
This damage could occur if the grid impedance is less than 0.15Ω.
CONNECTION TO THE ELECTRICITY GRID
DANGER:
•
Never collect gases, explosive/inflammable liquids or powders, nor acids and solvents! These
include gasoline, paint thinners and fuel oil (which, when mixed with the vacuum air, can form
explosive vapours or mixtures), and also non-diluted acids and solvents, acetones, aluminium
and magnesium powders. These substances may also corrode the materials used to construct
USE - EMPLOYMENT
4