SECTION 3 OPERATIONS AND CONTROLS
SU5 OWNERS MANUAL 2014
IMPORTANT FIRST STEP
Upon initial delivery, it is very important that the battery pack is properly charged. This is
required if the vehicle is to be stored for later use or is to be used immediately.
Check that the batteries are not damaged or leaking and that connections are tight.
NOTICE
: The following information does NOT apply to sealed batteries.
Remove the battery vent caps and inspect each cell for proper electrolyte level. The battery
manifold assemblies on vehicles with a single point watering system will require a ¼
counterclockwise turn to be removed for this inspection.
If the electrolyte level is below the plates add only enough water to cover the plates. See
SECTION 4 ELECTRIC SYSTEM
, BATTERY INSPECTION & MAINTENANCE.
NOTICE
: Do not overfill a cell. Electrolyte expands and can overflow during charging.
With the electrolyte level correct, use the on board charger to charge the batteries.
Charging is complete when the remote LED is steady green. See
SECTION 4 ELECTRIC
SYSTEM
, CHARGER OPERATING INSTRUCTIONS.
Vehicles without a single point watering system, after charging, refill cells to below the
bottom of the each cell vents. See
SECTION 4 ELECTRIC SYSTEM
, BATTERY
INSPECTION & MAINTENANCE.
Vehicles with a single point watering system will require completion of 4 to 5 charge cycles
before watering.
NOTICE
: If the vehicle is not going to be used the charger can remain connected to an
AC source. It has the capability to test and recharge the battery pack during storage.
INSPECTING THE VEHICLE
After battery charging, perform an inspection of the vehicle to ensure that it is in safe proper
working order.
Examine the contents of all packages and accessories that may have come in separate
packages with this vehicle. Make sure everything listed on the packing slip is there. Items
should not be broken or damaged.
Examine any visible wiring for obvious signs of damage. Check that all connections are secure.
Inspect the tires for obvious wear or damage. Check for proper tire inflation (32 psi
recommended). Make sure that all wheel lugs are secure.
Check the body, seats, trim and other external parts for obvious damage. Look for body
damage, jagged edges etc. that may cause personal injury.
Operate each of the following controls before turning on the power keyswitch.
Accelerator Pedal for smooth operation.
Braking Pedal, assure presence of a firm pedal with minimal travel.
Check steering for responsiveness and minimal play.
Key can only be removed when keyswitch is in the
“OFF” position.
3-1
Find replacement parts for your cart faster at
CartPros.com
