When replacement parts are required, use only genuine Columbia Industrial & Commercial
Vehicle parts.
No modifications or additions, which affect the mechanical or electrical integrity and the safe
operation of the vehicle, shall be made without the written approval of the manufacturer. If
such modifications are approved, the capacity, operation, and maintenance instruction
markings shall be changed accordingly. If in doubt about any modification, contact your local
Columbia Dealer or Columbia ParCar Corp. Customer Service.
Do not overload the vehicle. Never exceed the rated capacity as specified on the Vehicle
Nameplate.
Your safety and the safety of others depend on your safe operation and maintenance of this vehicle.
2.3 OPERATOR SAFETY INSTRUCTIONS
For personal safety and to maintain stability and control, operate this vehicle under these
conditions only. Failure to comply with these warnings may result in bodily injury and property
damage.
Do not drive this vehicle unless you are a qualified and trained operator and familiar with
the vehicle operational controls.
All vehicles should be operated from the driver’s side.
Never exceed the capacity ratings of the vehicle. Exceeding these limits may endanger
occupants.
Personal injury may result if body parts (arms, head, and legs) are not kept inside vehicle
while moving.
Allow only one occupant per seat. Do not start moving until all occupants are seated with
seat belts fastened, if equipped. Remain seated and hold on while vehicle is in motion.
Before leaving your seat, completely stop vehicle and lock parking brake. If vehicle is to be
left unattended, turn keyswitch to “OFF” and remove key.
Do not use accelerator to hold vehicle on an incline. Use brake.
Make sure directional keyswitch is in position for the desired direction of travel before
depressing the accelerator. Do not change the directional keyswitch while vehicle is
moving.
Drive slowly in turns and up and down grades. Do not make turns on steep hills or inclines.
Do not operate while under the influence of alcohol or drugs.
To avoid the risk of injury or vehicle damage, operate at maximum speed only on smooth
flat surfaces.
Allow additional stopping distance when traveling at higher speeds.
Do not drive this vehicle in hazardous areas unless this vehicle is approved and labeled for
such operation.
Keep a safe distance when following other vehicles and from the edge of ramps and
platforms.
Immediately report any accident or vehicle problem to your supervisor.
2.4 SAFETY CONCERNS
It is recommended that the operator and owner or renter of this vehicle comply with the OSHA
requirements as stated in the Code of Federal Regulations, Section 29, 1910.178, Powered Industrial
Truck Training Standard and the ANSI requirements as stated in Personnel and Burden Carriers ANSI
B56.8.
2-2
