To remove batteries:
Remove battery negative (-) cables.
Remove battery positive (+) cables.
Remove battery hold down.
Reverse these steps to reinstall the batteries (negative cables attached last) and to secure the charger.
Be sure to retighten the two wing nuts.
4.11 SINGLE POINT BATTERY WATERING SYSTEM
When equipped, this is a single point watering system for maintaining a sufficient electrolyte level in the
batteries.
NOTICE:
Do not operate this system on brand new batteries. See Section 3.1 for the initial
check on the electrolyte level of new batteries. Complete 4 to 5 charge cycles before using the
system.
System is to be used only after fully charging the batteries and batteries are warm.
The fill tube assembly which is used for adding water to the battery pack consists of a fill tube, one end
having a filter screen, the other having a female coupler and a rubber squeeze bulb.
Check the battery pack water level weekly by:
Inserting the fill tube filter end in an approved water supply.
Attaching the female coupler to the battery pack male coupler.
Squeeze the rubber ball until firm which indicates that filling is complete. Immediately disconnect the
couplers by depressing the push button on the female coupler. If the water supply is left connected
after the filling process is finished it could lead to an overfill.
4-10
