COLUMBIA VAC OPC1100, Manual

Page: 18 / 76

18 EN
INSTALLATION
Choosing the place for installation (fig. 3).
The device must be placed vertically on a flat surface, in a dry and spacious location. The
room should be ventilated. At least
20 cm
of clearance should be left around the device.
Water accumulates in the tank (8) . An attached hose (9) can be used for water discharge.
The method of installation is described in
“CONTINUOUS WATER DISCHARGE”
section.
OPERATION OF THE DEVICE
Any changes in settings are signalled by a sound.
CONTROL PANEL (fig. 2).
DISPLAY - this indicator has 4 functions:
- when the power is on, it displays the humidity in the room,
- when setting the humidity, it displays the value in the
‘20-80’ range,
- when setting the
‘TIMER’
function, it displays values in the
‘00-24’
range,
- if there is a problem with the device’s operation, it shows error codes.
Button
- is used to switch the device on/off.
After switching off with the button the device stores the set parameters.
After disconnecting from the power supply, the device returns to its factory settings.
Do not remove the power cord plug straight from the outlet to force the device to stop
directly.
The color of the circumference around the button indicates the humidity of the air:
-
blue
– humidity below
40%,
- green – humidity between 40 and 60% ,
-
red
– humidity above
60%
.
Red also appears in case of overfilling of the water tank and in case of a problem with the
device.
‘MODE’ button
- selection of a saved program:
- -
program I
– the device maintains humidity at the level of 60%, fan speed can be
selected. Selecting another humidity level turns off the program.
- -
program II
– the device maintains humidity at the level of 40%, fan speed can be
selected. Selecting another humidity level turns off the program.
- - program III – the device maintains humidity at the level of 20%, fan speed can be
selected, no other humidity level can be set.
‘SPEED/LOCK’ button
- selection of fan speed – single press of the button determines the fan speed
which is indicated by the controls: - quickly, - slowly. Speed selection is not
possible when program III is active, the buttons are locked and in night mode.
-
button lock – press and hold the button
for a few seconds.
Activation of the function is signaled by the control and deactivation by the button