14
•
EN
seleCting a stored programme
select the programme using the “
MODE
” button:
the device operates at the constant fan speed selected using the “
SPEED
” button.
the device simulates a natural breeze - t he fan speed changes cyclically.
the device simulates a light, natural, breeze - the fan speed changes cyclically.
timer
This function allows you to set the time after which the device will be automatically switched off.
The time can be set between 0.5 - 7.5 hours (half-hourly increments).
The activation of the function is indicated on the display
(2)
by the indicators “
0.5H
”, “
1H
”, “
2H
” and “
4H”
.
To activate the function, press the “
TiMER
” button until the sum of the values on the display
(2)
corresponds to the desired time value,
for example, if the device is to be switched off after 3.5 hours, the following indicators should light up
on the display: “
0.5H
”, “
1H
”, “
2H
” – 3.5 total.
To deactivate the function, press the “
TiMER
” button until all time indicators are off.
CLEANiNG AND MAiNTENANCE
NOTE
Before carrying out any maintenance or repair work, switch off the device and disconnect it
from the power supply.
It is recommended to clean the water tank
(11)
regularly.
The tank
(11)
can be completely removed from the device, after pulling out the pump -
Fig. 5.
Clean the casing with a soft, damp, cloth.
Do not use chemical solvents (e.g. benzene, alcohol, gasoline) as this could damage the surface or
deform the entire casing.
Do not immerse the device in water or any other liquid.
Do not spray the device with water.
FiLTER
The filter
(9)
should be checked regularly. To do this, first remove the screws securing the filter cover
(10)
and then remove the filter cartridge
(9)
.
If a replacement is necessary, remove the used filter from the cartridge and replace it with a new one.
Note
Do not turn the unit on without a correctly installed filter (9).
THE END OF THE DEViCE’S OPERATiNG CYCLE
Turn the device off.
Empty the tank
(11)
.
Remove the filter
(9)
, and, after thorough drying, install it in the device.
Wrap the device in a plastic bag and store it in a dry place.
