2007 Eagle Electric Golf Car Service Manual
© December 2007
8-7
Section 8 - Body and Chassis
Figure 8-15. Console Controls Wiring and Mounting
Directional Key
Switch
Replacing Directional Key Switch
NOTE: The directional key is non-removeable. If the switch is in-
operable, it is necessary to break the key off the switch to remove
it.
1. Break key to remove it from the key switch.
2. Remove nut and lockwasher securing key switch to front of
console.
3. Push the switch out of the console towards the front of the
vehicle.
4. Disconnect wiring and reconnect to new switch.
5. Install switch into console and secure with lockwasher and
nut. Make sure key slot is vertical and fl at side of nut faces the
console.
6. Install the directional key into the switch housing.
Replacing Headlight Switch
1. Remove plastic nut from back side of switch.
2. Disconnect wires from switch and remove switch from con-
sole.
3. Connect wires to new switch, place switch into console and
secure with plastic nut.
Replacing Battery Discharge Indicator (BDI)
1. Remove two nuts securing wires to BDI.
2. Remove two nuts and bracket securing BDI to console.
3. Pull BDI from console. Install new BDI to console with bracket
and two nuts.
4. Connect wires to BDI with two nuts.
STEERING WHEEL
Removing Steering Wheel
1. Remove steering wheel cover by carefully prying out from
steering wheel.
2. Remove Phillips head screws securing steering wheel to col-
lar (Figure 8-16).
3. Remove steering wheel nut from center of steering wheel.
4. Pull steering wheel from spined shaft.
Installing Steering Wheel
1. Make sure wheels are pointed straight ahead. Install steering
wheel on splined shaft.
2. Install steering wheel nut and tighten securely.
3. Connect collar to steering wheel with Phillips head screws.
Power On Off
Key Switch
Headlight Switch
Black-top
Blue-middle
Red-bottom
Battery Discharge
Indicator (BDI)
Find replacement parts for your cart faster at
CartPros.com
