Installation Steps:
WARNING: ALWAYS TURN OFF THE POWER SUPPLY FROM MAIN CIRCUIT BREAKER FIRST!
• Remove the LED luminaire from packaging and inspect for any damage. Handle LED luminaire with care.
• TO INSTALL WITH CHAIN MOUNT: Install the chain into the provided wire hanger. Secure the other end of the chain to a structure using hardware rated for
the load. Install the wire hanger into the slots on the top of the LED luminaire end piece. Make sure the wiring hangers are fully engaged into the slots on
the top channel.
• Connect the LED high bay wiring to incoming power lines, with black to black, white to white and green to green. Use only UL listed wire.
NOTE:
The purple and grey wires inside the driver compartment are 0-10V (low voltage) dimming wires. Connect to dimming low voltage wiring only.
• Clean all residues and fingerprints from the LED luminaire. Double check all hanging hardware before moving onto the next installation.
• Energize luminaire and ensure proper operation.
C: SURFACE MOUNTING
D: PENDANT HANGER
OPTIONAL: WIRE GUARD
For 3/8" IPS
CHB
Linear High Bay /
Instruction Manual
INDUSTRIALS /
CHB
Page
2/2
Rev.
09/07/18
© 2018 Columbia Lighting, a division of Hubbell Lighting, Inc. Because of continuing product improvement programs, Columbia Lighting reserves the right to change
specifications without notice. 701 Millennium Blvd. Greenville, SC 29607 / Tel
864.678.1000
/ Tech Support
864.678.1668
/ Website
www.columbialighting.com
