SmartLF Cx+40 Instruction Manual
Page 9 of 12
2
Utilities Program
2.1
Normalisation.
1. Insert the white calibration
target supplied with the
scanner matt side faced down.
2.
Click the ‘Full Normalisation’
button and allow it to run. This
takes about 5 minutes, and the
target will move through the
scanner during this time.
Remove the target when
completed.
NOTE: This calibration target is supplied with the scanner and should have a width of 103cm, if
the target is missing/damaged, any good quality large format paper can be used making sure it is
cut to 103 x 50cm
