10
Read Before First Use
•
At power on, the Dazzler FX will begin heating for use. It is recommended to
connect to your selected DMX controller and other machines at this time.
•
The Dazzler FX must be used in a well-ventilated area only. If the machine is
placed in too hot an environment (above 104 degrees) where there is limited
airflow, the machine’s heating protection system may cause a safety shutdown.
•
The Dazzler FX machine must be used horizontally on the ground only. The
machine should have 1 meter (3 feet) clearance on all sides. Keep away from
children, flames, flammable, and combustible materials.
•
Don't allow the Dazzler FX machine to run out of powder for an extended time. If
the machine is allowed to run empty, it may cause the motor and heater to be
damaged.
•
Turn off the power before adding powder and do not allow powder to enter the
inside of the housing as internal electrical damage may result.
•
If the spark output is low, or there is noise from motor, or the machine stops
creating spark altogether- do not attempt modify or repair the machine by yourself.
Please contact the dealer of purchase of ColorKey directly for more support.
•
To better protect the life and longevity of your Dazzler FX units, it is advised to use
the effect in small increments of 10-30 seconds. If the machine continues to work,
heat up and consumes a whole package of powder, please cut off the power and
make the machine stop working for more than 10 minutes.
•
When the machine is not being used, or will be in storage for a long time, please
do not keep the powder loaded in the tank. Please be sure to spray out the powder
using the remote, manual or DMX clearing functions to prevent the machine from
becoming blocked or lodged with powder.
•
When finished loading Dazzler FX Spark Powder, be sure to securely fasten the
Storage Tank cap, otherwise it could allow for safety issues.
•
The power supply can connect to a maximum of 6 machines in series.
•
If the machine is overturned or impacted during use, it will automatically shut down.
To correct, turn off the power, check all connections are not damaged. When
confirmed ok, it can be used normally after restarting.
