Plug Into
Power Driver
Board J-138
(B.B.)
Optional
:
Only use the male-to-male
adapter to reconnect a
pre-existing cable back
into J-138
Plug Into
ColorDMD
PWR
J-604
J-603
A/V Board
Power Driver Board
Route the new ColorDMD
Power Cable along with
the existing cables for a
clean install.
Figure E
J-138
Locate the included 4-pin ColorDMD power cable. One end of the
cable has a single connector (see Fig. D). Plug this connector
into the PWR header (see Fig. C) on the ColorDMD.
Plug the other end of the new ColorDMD Power Cable (see Fig. D)
into J-138 on the WPC95 Power Driver Board (see Fig. E). If an
existing cable is currently plugged into J-138, disconnect it before
connecting the ColorDMD power cable
.
If you disconnected a cable from J-138 in the previous step, use
the included male-to-male adapter to re-connect this cable to the
available center connector on the ColorDMD cable (see Fig. D).
Otherwise, do not connect the male-to-male adapter and store it
in a safe place.
7
8
Figure D
9
STEP
STEP
STEP
TIP
ALL RIGHTS RESERVED - US PATENT 8,773,452 B2 - COPYRIGHT 2016 - COLORDMD DISPLAYS LLC
