Troubleshooting
Problems
Reasons
Remedy:
Power cord is not plugged
in well
Plug in the machine
Machine does not work
Problem from the power
supply
Check if the other machines work
normally
Set temperature below or
close to the water
temperature
Check the setting
Water temperature does not
increase
Set heating time is too
short
Prolong the heating time.
Program is wrong
Unplug the power and connect the
power one minute later
Temperature sensor is
invalid
Repaired by the specialist
Water goes on heating after
the set temperature is
reached
The circulator does not
rotate
Repaired by the specialist
Machine does not be put
into water
Unplug the power, then put the
machine into the water and connect
the power one minute later
E01 appears on the display
Water level is too low
Add water, make sure the water
level is between the MIN and MAX
line
Air inside the pump
After fill water into the tank, shake
the machine for a few times to
discharge the air out of the propeller
of the pump
High decibel noise from the
pump
Debris inside the pump
Clean the machine and pump
according to How To Clean in the
manual (Or ask specialist to clean
the machine)
**
** During the use of the machine, if any other problems arise, please ask specialist to check the machine. Do not attempt
unauthorized repairs to avoid accidents.
