COLOP e-mark create, Instructions For Use Manual, Page: 7 / 16

6 7
Printing 2
9
In
Imprint settings choose either two or three line printing
Once your design is ready to go, select the e-mark® create icon in the top right corner
The mobile printer will beep and the app will signal when your motif has been received
Follow the chart to print each line. Do not lift your device on the page until printing is complete
The e-mark® create will beep to indicate when you should change direction
or 3 lines
Continual
10
1
2
3
printing
1
2
3
4
5
1
2
3
4
Printing using
11
the Ribbon Guide
The COLOP e-mark® Ribbon Guides are the perfect
tool to print on the COLOP e-mark® Ribbon or the
COLOP e-mark® endless labels.
Don’t forget to activate Continual Marking in Imprint settings
Thread the ribbon or endless label through the Ribbon Guide by first
going down and then up
Place the e-mark® create in middle of the Ribbon Guide
Hold down the end of the ribbon and slide the Ribbon Guide along
with the e-mark® create as long as you want to print
Note:
Do not pull the ribbon to avoid colour smears
Do not lift up the e-mark® create during the printing process to avoid print
head cleaning stains on the material
Use the respective Ribbon Guide for the 10mm, 15mm and the 25mm ribbon
Use the 15mm Ribbon Guide for the endless labels
1
2
3
4
Make sure Continual Marking Continual Marking is turned on in Imprint settings Imprint settings
Once your design is ready to go select the e-mark® create icon in
the top right corner
The e-mark® create will beep and the app will signal when
your print has been received
Swipe the e-mark® create to print your design. The e-mark® create
will continue to print as long as it is in motion