EN
G
LI
SH
5
4. Assembly
1. Prevent unintended starts by pulling out the plug from the mains before attaching
the blade assembly and glass jug to the motor unit. Check that the power switch
(7) is in the 0 position.
2. Turn the glass jug upside down.
3. Place the rubber seal (4) on the bottom of the glass jug.
4. Place the blade assembly (5) onto the rubber seal. Be careful, the blades are sharp.
5. Place the flat face of the locking ring (6) onto the blade assembly. Twist the locking
ring clockwise until it locks into place. Make sure that it is tightly secured.
6. Place the glass jug onto the motor unit (8).
5. Things to consider before using the blender
Important:
Read this before using the product.
• Before the glass jug is placed on or removed from the motor unit, make sure
the blender is turned off and that no parts are rotating.
• Never shake the glass jug while using the blender. If the contents stick to
the sides of the glass jug: Switch off motor and clear the sides with a spatula.
• Do not start the blender again before you have properly replaced the lid.
• The glass jug can withstand contents with temperatures up to 60 ˚C.
• Do not subject the glass jug to sudden changes in temperature as this might
cause the glass to crack.
6. Use
1. Place the assembled glass jug (9) onto the motor unit (8) and place the blender
on a flat surface.
2. Place the items to be blended into the glass jug (3).
3. Push the lid (2) firmly onto the glass jug. Screw the lid insert (1) clockwise into
the hole in the lid.
4. Plug the power lead into an electrical socket and switch the blender on by turning
the power switch (7) to an appropriate setting for the contents of the jug:
P
– The pulse setting is spring-loaded so the motor only runs as long as switch
is held on the P mark. Adapt the length of pulse to the consistency of the jug’s
contents. This setting can be used for crushing ice or items requiring a lot of power.
0
– Off
1
– For light ingredients and thin fluids.
2
– For blending solid foodstuffs and thicker fluids.
5. Turn the power switch (7) to
0
and pull out the plug after use.
N.B.
• Never run the blender for more than 2 minutes at time. Let the motor cool down
for a few minutes before using it again.
• Never run the blender empty.